Towbar BMW SERIE 4 COUPE F32 from 10/2013 to 09/2020 : Swan neck towbar incl. 7 pin universal multiplex wiring kit IMIOLA 

Swan neck towbar Imiola

The IMIOLA swan neck towbar is the ideal solution for frequent use.

Designed specifically for your vehicle, the swan neck towbar allows you to tow any type of trailer, bike carrier, boat carrier, caravan, etc. The swan neck towbar is more aesthetically pleasing than the angled towbar, and with this towbar it is also possible to remove your towbar after use (using a simple English key).



In addition to strictly respecting the alignment and centre distances of the holes on the chassis of your vehicle, this towbar is protected against all external aggressions, and in particular climatic ones, by a cathodic immersion varnish (KTL), which prevents the oxidation of the towbar and consequently the chassis of your vehicle.
All towbars are tested and approved in accordance with Directive 94/20 EC and 55 CER.
The assembly is made easy for you thanks to the assembly manual specific to your vehicle with pictorial descriptions. 

IMIOLA

7-PIN + ELECTRONIC BOX FOR MULTIPLEX VEHICLE

The towbar electric wiring kit the practical solution to power your trailer lights, bike carrier or any other towing accessory. While remaining economical, the ready-to-install 7-pin wiring kit with electronic box allows for easy installation on all multiplexed vehicles.

The matic V7 relay does not require any reprogramming of your vehicle. So unlike the specific wiring kit, you don't have to go to your manufacturer or to a garage to reprogram your car.

You also have a picture of the assembly instructions. The approximate time to assemble a wiring kit is about 15-30 minutes.

WIRING KIT CHARACTERISTICS

Number of pins	7
Reprogramming	No
Compatibility Bulb	Alltypes : traditional, LED, à dual intensity
Output protections	- outputs protected against short circuits -Reverse polarity protection -IP50 Protection
Pre-mounted terminal on the box	Yes
Warranty	2 years

• The wiring kit is connected to the rear lights, so no reprogramming is required, making it easy to fit.
• In addition, the wiring kit does not affect the operation of the reversing radars.
• The wiring kit allows you to transfer information from your lights to your trailer (turn signals, brake lights, etc.).

BENEFITS AND SECURITY

Wiring Kit

• Allows you to supply electricity to the lights of your trailer and bike carrier
• No reprogramming required
• Fits all multiplexed vehicles
• Comes pre-wired with 2400mm sheathed wires, allowing the module to be mounted on either side
• Power wire (more permanent) is 5.5m long

TUV certification : ISO 9001:2008 system certificate

IMIOLA towbars comply with all applicable European standards, if you want to know more about IMIOLA towbar certifications, standards and guarantees click here

CONTENT OF THE PACK

• Robust steel fittings
• Bolts and nuts
• Ball joint cover
• Wiring kit holder
• Swan neck towbar ball joint
• Assembly instructions
• 7-pin wiring kit + V7 relay box + Fixing + Assembly instructions

ACCESSORIES